Skip Images

Rohde & Schwarz HZC50 Current Clamp

AC/DC current clamp with Hall sensor for ±30 A, DC–100 kHz bandwidth, 100 mV/A output, 4 mm banana plug and CAT III rating for multimeters and oscilloscopes.

7 150 SEK

This AC/DC Current Probe is used to measure currents from 1mA to 30 A over a broad frequency range. The measurement principle is based on the Hall Effect that registers the magnetic field generated by the current flow. Even for complex waveforms a high degree of measurement accuracy is achieved. The output voltage is proportional to the measured current and well suited to be displayed on an oscilloscope. The current probe complies with the safety standards defined in IEC/EN 61010.
 
Specifications
  • Measurement range: ± 20 Aeff/30ASpitze
  • Accuracy: ± 1% from measurement value ± 2mA
  • Bandwidth: DC…100 kHz (0,5 dB)
  • Resolution: ± 1mA
  • Output voltage: 100mV/A
  • Load impedance: › 100 kΩ II ≤ 100 pF
  • Max. Voltage: 300 Veff or DC
  • Output cable/Connector: 2m (50Ω)/BNC
  • Measuring category: CAT III