Tekbox EMCview PC-software for EMC pre-compliance testing of radiated and conducted emissions

• Numerous pre-configured project files for CISPR-xx (EN550xx) emission measurements
• Graph supports two complete measurement runs, same as in test house
• Fast Quasi-Peak scan of critical peaks, immune to frequency drift of the selected peaks
  Configurable limit lines and segment files
• Configurable correction files for cable, LISN, amplifier, antenna etc.
• configurable margins for the identification and selection of critical peaks
• Supports import and overlaying of reference measurements for comparison purpose
• Linear or logarithmic frequency axis
• Automatic creation of test reports
• Many import/export-functions

Application:

• In house measurement of EMC behavior during product design phase
• EMC training in lab, school and university
• Pre-compliance test of products before submitting it to the test house
• Test cost reduction
• Reduced time to market

Tekbox EMCview is a PC-software for user friendly EMC pre-compliance testing of radiated and conducted emissions.

It is a perfect complement for automated testing using Tekbox LISNs and TEM Cells.

A built in amplitude correction enables correction and conversion coefficients for cables, amplifiers, attenuators, LISNs, TEM cells, antennas, RF current probes, striplines and capacitive coupling clamps.

There is no need for a time consuming setup.

The SW is ready for measurements straight after installation.

All emission related CISPR-xx (EN550xx) measurements and a few automotive manufacturer standards are pre-configured in corresponding project files.

The graph supports two complete measurement runs such as for example Average / Quasi-Peak or Peak / Quasi Peak and alternatively a fast Quasi-Peak scan of critical peaks.